TO CONFIGURE A PHONE CASE, FOLLOW THESE STEPS:
1. Select Phone Cases under Products tab.
2. Select Options tab to access tools to configure your case.
3. Select your phone model. (Sorry, not all model available for all manufactures, though latest models for major brands will be added as available.)
4. Configure the image to fit your phone model using the tools. There is an alert if the image is sized too small. Be sure to size the image large enough to cover the entire surface of the phone graphic or the areas not covered by the photo will show up as white or gray. Go slightly too big if you want to be sure, or you can leave the white or gray if you are okay to have the image only cover part of the case.
Tips: Because all phone models have different shapes and sizes as well as camera placement, not all images work well for all phone models.
5. To configure a different image, you will need to go back to the Phone Cases main page, select the new image, and then start over.
The snap case and tough case are both printed on a thin plastic (polycarbonate) shell, but the tough case has a rubber (thermoplastic polyurethane) layer between the outer shell and the phone for additional protection.
The flexi case is a semi-opaque rubber (thermoplastic polyurethane) with the print on it.
Once you have selected your phone model and configured the image using the tools, you can add it to the cart. Latest models coming soon - be sure to check back!
Please send comments on how you think this interface could be better so I can pass them on to the developers for my printers. Unfortunately, I am stuck with the way they build these product interfaces until they improve or I move my site....